Perform two important tasks Enable Info Site Password Then Disable the Warning notify and click Save. Uncheck all these boxes before proceeding. You will be left with Additional Filters, Block Wan Requests, and Impede WAN. Should also Disable the SPI firewall by selecting the Firewall The Services tab and Disable both DNSMasq and ttraff These would depend on the options that the router under questions supports and vary from one user to another.Īfter the basic settings are complete, remember to click Save at the bottom of the page.
You can, therefore, select the remaining wireless options according to your liking. Select Channel width: 20 MHz for 2.4 GHz and HT40 for 5 GHz.Select the wireless channel that is used the least in your area.N-only gives the best performance with the devices that support N” Tip! “Select the right mode for the clients. Click on Basic Settings and provide the following information: Next, you have to configure the setting for 2.4 GHz and 5 GHz channels. Moreover, convert the operating mode to the router and hit Save. In the Time Settings, enter the following information:Ībove all, now from the Setup option, move to the Advanced Routing tab. Don’t check the use of DNSMasq for DNS.Ĥ.
Tip! We recommend allocating a static IP Address till the access point in the router that is also based on the access point of its MAC address.
Select Setup and then click on the Basic Setup tab. Step 1įirstly, connect the router Web interface by providing an IP address.ġ. Now let us take you through a step-by-step guide to create an access point using a DD-WRT router. If you want to restart or reset the device then there are also some risks concerned to it, if it is not done in the right way The DD-WRT access point can work without having to perform 30-30-30 reset. After all process, you can again reset the password of the router.
The best part is that you can do this only by following five easy steps! How To Convert DD-WRT Router Into An Access Pointīefore you begin, please keep in mind that although it recommends that you clear existing router settings by restoring default, it is necessary. Firmware commonly affects how a device collaborates with other devices.”īy converting your DD-WRT router into an access point, you can enhance your router’s wireless coverage of signals. Therefore, it is widely available for many affordable routers and models.įlashcard! This kind of program is permanent integral with a piece of hardware, such as a router. There is no need to invest in a new access point when you can have it using an old router without spending any money! DD-WRT access point comes without any cost.